4 CH Active H/L 5V Relay Module

4 CH Active H/L 5V Relay Module

    • Login to view ProMaker's Insider Price!
    • $1.98
  • Ex Tax: $1.98
    • 10 or more $1.88
    • 30 or more $1.68
    • 100 or more $1.63
  • Cashback: 3%
  • CytronCash Balance: Login
  • Availability:
    28

Accessories you may need

Enter desired quantity before clicking 'Add to Cart' button

  • Total accessories: $0.0
  • Grand total: 1.98

  • Product Code: BB-RELAY-5V-04
  • Warranty Period: 12 months
  • Shipping:

Relays are always good to have especially for electronics projects. Relay itself offers two main benefits:

  • Isolation of low voltage system against high voltage system, example 5VDC and 240VAC
  • Allow electronics with low voltage to control high power load, example from Arduino to AC light bulb.

This is not an ordinary Relay breakout. It comes with 4 channels of 5V activation relay, ready to control 250VAC at 10A. Extra isolation with opto-coupler at the front end of control, and the activation logic for each channel is configureable via mini jumper. In simple words, each relay can be configured as 5V(High) activation or 0V(Low) activation. And Yes, each relay, individually. This is the universal Relay breakout board that I like it.

This is ready breakout board with four (4) 5V activated relays, with 3 screw terminals for each relay (NO, NC, COM) and screw terminals for control signal from microcontroller such as Arduino. Each control signal is opto-isolated, protected. It even comes with activation LED indicator for each relay. Easy to use and suitable for beginner, and of course student too.

If you need to control AC or high current, high voltage load, this will be the perfect board.

Features:

  • 5V 4 channels relay module
  • Configureable Activation Logic, High or Low, via mini jumper
  • Maximum Current Rating: 10A
  • Maximum Voltage Rating: AC 250V
  • Can control various appliances with large current and high voltage
  • Can be controlled directly by microcontroller such as Arduino, 8051, AVR, PIC, DSP and ARM
  • Build in 4 units of Opto-Isolator for extra isolation and protection to controller.
  • A power indicator LED, Green
  • Each relay comes with an indicator LED

Resources:

Hi, Can the power for relay coil be separated from power to optocouple - like other boards that have Vcc and Vcc-JD ? This is because raspberry PI GPIO is 3.3VDC and the Relays are 5VDC. ( Lee, 16/07/2020 )
Hi, for further technical assistance, you may drop an email to support@cytron.io and our technical team will assist you as soon as possible. Thanks :)
Hi, can one screw the jumper wires from the Arduino into the inputs marked IN1-IN4? ( Hua Jie , 25/06/2020 )
Hi, yes can. Thanks :)
Hi there, wondering whether the module is capable of supporting higher than 5V, maybe 12V or higher? What is the maximum supported voltage? Thx ( C.H.LEE , 15/02/2020 )
Hi, yes. But, resistor is needed to be added at the input as it uses optocoupler, rating 5mA. Thanks :) 

Ask a question

Note: HTML is not translated!
  • 5 out of 5
                  
Total Reviews (45)
  • 5
    97.78%
  • 4
    0%
  • 3
    2.22%
  • 2
    0%
  • 1
    0%

Tags: 4 channels, Opto isolated, Active High, Active Low, trigger, optocoupler, H/L Level