CSI to HDMI Converter boards - RPi Camera Cable Extension

This is an adapter that uses the HDMI signal to extend the CSI signal of Raspberry Pi cameras, which could be much longer than using an extension ribbon cable. It’s used in pairs and you need another standard HDMI cable to use this adapter.

The CSI-HDMI adapter board is designed for Raspberry pi camera board (V1, V2, and HQ camera) to extend the camera over the long cables while keeping the high-speed CSI signals away from noise and interference.  

Note: It's not recommended to use this with Camera V3 as it may result in a flickering display problem.

Note: Raspberry Pi board and standard HDMI cable are not included in the pack. Please get them separately.

By using a high-speed HDMI cable, the camera can run over 10 meters, which greatly extends the usage of the Raspberry Pi cameras. In addition, to extend the camera signal, the adapter board provides another 3 signals to be extended with the camera signals together via the headphone jack connector. It can be used to extend standard audio signals, GPIO signals, or other sensor signals according to users' needs. If you need a longer and stronger cable with solid connections, this is the right thing for you.

• Supports:
  • Raspberry Pi 5
  • Raspberry Pi 4B
  • Raspberry Pi 3B+
  • Raspberry Pi 3B 
  • Raspberry Pi Model A+
  • Raspberry Pi 2
  • Raspberry Pi Zero (you will need a different CSI ribbon cable for Pi Zero)
  • NVIDIA Jetson 
• HDMI cables can be up to 10 meters (more than 10 meters wasn't tested)
• Reserved microphone and headphone jack for audio or GPIO signals
• Three additional solder pads are available (same signals as a headphone jack)
• Dimension (W x L): 27.63 x 25.00mm

• 2 x Arducam CSI to HDMI Cable Extension Module
• 2 x 60mm 15pin FPC cable
• 4 x M2 screw

• User Manual