Grove Shield for Arduino Nano V1.1 - Support 3.3V

Grove Shield for Arduino Nano provides you with a simple way to connect with Arduino Nano. This shield helps you get rid of breadboard and jumper wires by pulling out the pins of the motherboard and expanding to 8 Grove connectors. This shield pulls out the pins of the motherboard and expands to 8 Grove connectors, including 3 Grove digital connectors, 3 Grove analog connectors, 1 Grove I2C connector, and 1 Grove UART connector.

Note: The Arduino compatible board is NOT included in the packing list.

Pinout

You can check at the backside of the shield.

Dimension:

• It pulls out the pins of the Arduino Nano board and expands to 8 Grove connectors:
  • 3 Grove digital connectors
  • 3 Grove analog connectors
  • 1 Grove I2C connector
  • 1 Grove UART connector.
• Supports Arduino Nano & Maker Nano boards:
  • Arduino Nano
  • Arduino Nano Every
  • Arduino Nano 33 IoT*
  • Arduino Nano 33 BLE*
  • Arduino Nano 33 BLE Sense*
  • Maker Nano*
  • Maker Nano RP2040*

*Note: To work with Arduino 33 serial boards and Maker Nano boards, please switch the VCC power to 3.3V. If the VCC power supply is switched to 5V, the development board may be damaged!

• It comes with VCC 3.3V/5V switch
• Operating voltage: 3.3V/5V
• Operation temperature: -25℃ to +85℃
• Analog ports: 3
• Digital ports: 3
• UART ports:1
• I2C ports: 1
• Size: 45mm x40mm

Packing list:

• 1 x Grove Shield for Arduino Nano V1.1 - Support 3.3V

• Getting started with Grove Shield for Arduino Nano