The Sound sensor module is a simple microphone. Based on the power amplifier LM386 and the electret microphone, it can be used to detect the sound strength of the environment. The value of output can be adjusted by the potentiometer. This module can easily integrate with logic modules on the input side of Grove circuits and its output is analog. With its tiny size and high performance, it is perfect for your Raspberry Pi audio detection project and interactive project.
For all Grove users (especially beginners), we provide you guidance PDF documents. Please download and read through Preface - Getting Started and Introduction to Grove before your use of the product.
Based on the picture above, the grove shield for Arduino is stacked with Seeeduino V4.2. Of course you can use that shield with Arduino board too :)
You can get grove HAT for Raspberry Pi here. It may not be the same as product above but still can use with Raspberry Pi.
You can also get the grove wrapper for a tidier and nice presentation of the project:
Get the compatible Grove Wrapper here:
Note: Controllers and Grove Wrappers are sold separately.
- Grove compatible interface
- Low quiescent current drain: 4mA
- 2.0cm x 2.0cm twig module
- Minimum external parts
- Applications Ideas
- Simple microphone
- Sound detection
- Easy project operation: Grove compatible interface
- Analog output signal
- Based on the power amplifier LM386
- Operating Voltage: 3.3V / 5V
- Operating Current(Vcc=5V): 4 to 5mA
- Microphone sensitivity(1kHz): 52 to 48 dB
- Microphone Impedance: 2.2k Ohm
- Microphone Frequency: 16 to 20 kHz
- Wide supply voltage range: 4V - 12V
- 1 x Grove - Sound Sensor
- Grove 4 Pin Buckled 20cm Cable
Total Reviews (16)