Grove to SVG Cable - 200mm length

Looking for Grove to SVG cable to connect your Octopus modules to micro:bit expansion boards? 

This 20cm long cable is a fantastic chimera cable fitted with an SVG (Signal Voltage Ground) connector on one end, and a Grove connector on the other. This cable can be used with Elecfreak's Octopus modules to easily connect to Grove sockets and boards, such as Edu:bit and Reka:bit.

A good example is using the Octopus modules with REKA:bit.

Note: Octopus Digital Push Button Brick is NOT included in the pack.

• Fitted with SVG connector on one end, and a Grove connector on the other.
• Compatible with Elecfreak's Octopus modules to easily connect sensors to grove sockets and boards, such as Edu:bit and Reka:bit.
• Pin Definition:
  • S (Yellow) - Signal
  • V (Red) - VCC
  • G (Black) - GND
• Power (both Red and Black) cables are connected to the GROVE connector's power respectively.
• Cable length: ~200mm
• The S (Signal) of SVG wiring is connected to the side GPIO of GROVE connected. For example in the photo below, the GROVE port at the most left, The Signal (yellow) of the Octopus module is connected to P0 of the GROVE connector. So when you develop the program/makecode, you will need to program the P0, NOT the P1.

• 1 x Grove to SVG Cable - 200mm length