The MPU-6050 is a serious little piece of motion processing tech! By combining a MEMS 3-axis gyroscope and a 3-axis accelerometer on the same silicon die together with an onboard Digital Motion Processor™ (DMP™) capable of processing complex 9-axis MotionFusion algorithms, the MPU-6050 does away with the cross-axis alignment problems that can creep up on discrete parts.
This is the breakout board for the MPU-6050 makes this tiny QFN package easy to work into your project. Every pin you need to get up and running is broken out to 0.1" headers, including the auxiliary master I2C bus which allows the MPU-6050 to access external magnetometers and other sensors.
List of hardware: 1️⃣ GY-521 MPU6050 6DOF Accelerometer + Gyro: https://www.cytron.io/p-sn-mpu6050 2️⃣ Maker UNO: https://www.cytron.io/p-maker-uno 3️⃣ Breadboard 8.5x5.5cm: https://www.cytron.io/p-bd-bb-0508 4️⃣ Acrylic Base Plate for Arduino Uno: https://www.cytron.io/p-hd-ard-bp 5️⃣ Male to Male Jumper Wire: https://www.cytron.io/p-wr-jw-mm65
Warranty Period: 12 months
Features
I2C Digital-output of 6 or 9-axis MotionFusion data in rotation matrix, quaternion, Euler Angle, or raw data format
Input Voltage: 3.3 - 5.0V
Tri-Axis angular rate sensor (gyro) with a sensitivity up to 131 LSBs/dps and a full-scale range of ±250, ±500, ±1000, and ±2000dps
Tri-Axis accelerometer with a programmable full scale range of ±2g, ±4g, ±8g and ±16g
Digital Motion Processing™ (DMP™) engine offloads complex MotionFusion, sensor timing synchronization and gesture detection
Embedded algorithms for run-time bias and compass calibration. No user intervention required
The MPU-6050 is a serious little piece of motion processing tech! By combining a MEMS 3-axis gyroscope and a 3-axis accelerometer on the same silicon die together with an onboard Digital Motion Proces..