The VL53L0X V2 time-of-flight range-finding sensor is a new generation of laser ranging module. The VL53L0X is a Time of Flight distance sensor like no other you've used! The sensor contains a very tiny invisible laser source and a matching sensor. The VL53L0X can detect the "time of flight", or how long the light has taken to bounce back to the sensor. Since it uses a very narrow light source, it is good for determining the distance of only the surface directly in front of it. Unlike sonars that bounce ultrasonic waves, the 'cone' of sensing is very narrow. Unlike IR distance sensors that try to measure the amount of light bounced, the VL53L0x is much more precise and doesn't have linearity problems or 'double imaging' where you can't tell if an object is very far or very close.
The VL53L0X can handle about 50mm to 1200mm of range distance, yes, that is 1.2 meter :)
The sensor is small and easy to use in any robotics or interactive project. Since it needs 2.8V power and logic we put the little fellow on a breakout board with a regulator and level shifting. You can use it with any 3-5V power or logic microcontroller with no worries. Each order comes with a small piece of header pin. Solder the header onto your breakout board with your iron and some solder and wire it up for instant distance-sensing-success!
Note: The header pins come without solder, so you will need to solder it.
Communicating to the sensor is done over I2C with an API written by ST, so its not too hard to port it to your favorite microcontroller. We've written a wrapper library for Arduino so you can use it with any of your Arduino-compatible boards.
- Working voltage: 3 ~ 5V
- Interface/Communication method: IIC or I2C
- Measurement absolute distance: 2m
- Typical measurement distance: 1.2m
- 1 x VL53L0X V2 Laser ToF Distance Sensor Module
- 1 x 10-way header pin