Getting Started With MDD3A Motor Driver Using Arduino

Getting Started With MDD3A Motor Driver Using Arduino

INTRODUCTION

MDD3A is a motor driver which have the same concept like Maker Drive but with the higher specs. In this tutorial, I will show how to get started with MDD3A motor driver using Maker UNO (Arduino).

VIDEO

This video will show you how to get started with MDD3A motor driver using Maker UNO (Arduino)

Untuk versi bahasa Melayu, sila rujuk video dibawah.

 

HARDWARE PREPARATION

Below is the list of the items used in the video.

Wiring connection table.

Maker UNOMDD3ADC MotorBattery
 Terminal M1AMotor 1 
 Terminal M1BMotor 1 
 Terminal VB+ Positive
 Terminal VB- Negative
 Terminal M2AMotor 2 
 Terminal M2BMotor 2 
Pin 3Pin M1A  
Pin 9Pin M1B  
5V5Vo  
GNDGND  
Pin 10Pin M2A  
Pin 11Pin M2B  

Sample Code

For the sample code, you can utilize the example code provided in Cytron Motor Drivers Library. Please install the library in Library Manager first. Then, open PWM_PWM_DUAL example (File - Examples - Cytron Motor Drivers Library - DUAL_DUAL_PWM).

Thank You

References:

  1. Getting Started with Maker Drive and Arduino

Thanks for reading this tutorial. If you have any technical inquiry, please post at Cytron Technical Forum.

Related Products