Description
If you Raspberry Pi computer module , CM3 and CM3L , this board is for you. The Compute Module IO Board Plus is for you. It is a development board which you can plug the Raspberry Pi Compute Module into, and make use of the resources of Pi more flexibly. It is compatible with the Raspberry Pi Compute Module 3 from the Raspberry Pi Foundation, along with various common use components.
Warranty Period: 12 months
Features
Compatible with the Compute Module IO Board V3 from Raspberry Pi Foudation: Raspberry Pi GPIO header, for connecting sorts of Raspberry Pi HATs Arduino connectivity, also supports Arduino shields 1-WIRE interface, for connecting single-bus devices like DS18B20 4x keys, 4x LEDs, 1x Buzzer, for I/O testing Onboard USB HUB, allows connecting more USB devices IR receiver, IR remote control is available Onboard USB TO UART, for serial debugging Sensor interface 10-bit ADC, 38KSPS, 11-ch (6-ch for Arduino interface, 5-ch for sensors) 16-bit DAC, 2-ch Onboard RTC, one of the most common and useful functions Compute Module IO Board Plus Overview:
Compute Module interface : for connecting Compute Module 3 OR Compute Module 3 LiteCompute Module GPIO header : breakout all the Compute Module pinsRaspberry Pi GPIO header : for connecting Raspberry Pi HATsCSI interface : camera ports, for connecting Raspberry Pi CameraDSI interface : display ports, for connecting Raspberry Pi LCDHDMI port USB ports : for connecting USB devicesUSB SLAVE interface: allows you to burn system image in to Compute Module 3USB TO UART interface : for serial debuggingArduino header : for connecting Arduino shieldsAD/DA input/output screw terminals 1-WIRE interface : for connecting single-bus devices like DS18B20Sensor interface Power port : 5V 2.5AFE1.1S : USB HUB chip12MHz crystal CP2102 : USB TO UART converterMicro SD card slot : insert a Micro SD card with pre-burnt system, to start up Compute Module 3 LiteTLC1543 : AD converterDAC8552 : 16-bit DAC, 2-chDS3231 : high-precision RTC chip, I2C interfaceRTC battery holder: supports CR1220 batteriesVoltage regulator : 3.3V / 2.5V / 1.8V LFN0038K : IR receiverBuzzer Power indicator ACT indicator : indicating the Micro SD card statusUser LEDs User Keys BOOT selection EN: enable the PC to access SD card/eMMC through USB SLAVE DIS: the Compute Module will boot from SD card/eMMC VGx power selection : config the I/O levelUSB HUB enable jumper : HUB enable and USB SLAVE power selectionADC/DAC configuration : config the power supply and reference voltage of ADC/DACPeripheral configuration : config the control pins of UART, user keys, user LEDs, 1-WIRE interface, IR receiver, and buzzerArduino AD selection :Connect 1 and 2: Arduino A0-A5 as digital control pin Connect 2 and 3: Arduino A0-A5 as AD input Dimension:
Packing List
1 x Compute Module IO Board Plus 4 x PCB spacer (5mm) preassembled
Reviews
Average Rating: 4.5 out of 5
Tags: WaveShare ,
13532 ,
CM3 IO Board ,
Raspberry Pi ,
CM3